Vision & Values Office Interior Design 3D

1 – Preparation

With the paper tape, attach and align the sticker on the wall and pass over with the squeegee to flat the transfer paper, the vinyl and the liner

2 – Application 1 of 5

Apply another paper tape vertically right in the middle. this will be the final position for your sticker.

3 – Application 2 of 5

Grab the left half and gently pull the transfer paper (the first layer). the vinyl should stick to this transfer, if not try to squeegee a little bit more on that area. then, cut the paper liner (bottom layer).

4 – Aplication 3 of 5

Beggining from the center of the sticker (above the tape) paddle up and down until you reach the end of the design, always from the middle to the borders.

5 – Application 4 of 5

Remove the paper tape and repeat de 3rd step, this time on the right side.

6 – Application 5 of 5

Wait about 10 to 15 minutes. afterwards gently begin to remove the transfer layer, pulling backwards and parallel to the wall, confirming that your new decoration stays on the wall.

7 – 3D Letter Application 1 of 2

Use glue to hang the letters

8 – 3D Letter Application 2 of 2

Stick the letters on the wall using the alignment marks

ENJOY YOUR ARTWORK!